Parameter
[Direct access]
Determination of an output to signal the brake
over-excitation.
Determination of the delay in ms with which the
starting torque is to be activated.
Definition of an output to signal that the lift is
carrying out a Temperature Run.
Determination of an output to signal that the lift
is running (driving signal applies).
Determination of an output to signal that the lift
is running (driving signal applies).
Definition of an output to control a hinged
stanchion.
Determination of an output for the emergency
stop. If an emergency stop is initiated, the
following actions will be conducted:
❑ immediate stop of the
installation
❑ deletion of all car calls
❑ landing calls no longer accepted
It is only after entering a car call, that normal
operation will be restored.
Determination of an output for the emergency
stop. If an emergency stop is initiated, the
following actions will be conducted:
❑ immediate stop of the
installation
❑ deletion of all car calls
❑ landing calls no longer accepted
O: Movement dir. is
changed
Definition of an output, which is activated at
every change of direction, also during the post-
regulation or inspection travel, in order to
control a counter. This is necessary in the case of
lifts with components which are only permitted
to exceed a certain number of travels /
directional changes, e.g. Plastic ropes.
Definition of an output to activate a call to the
rescue service signalling the end of alarm and
the intergration of rescue operation.
This parameter is an obligation of EN81-28
Definition of an output signalling the active
emergency call.
Definition of an output signalling to speak during
an emergency call.
To Next Page
Loading...
Need help?
General