Humidity Sensor
Type CMOS
Humidity 0 to 100% RH
Accuracy at 25° C ± 2% RH from 10 to 90% RH
Response time 4 seconds or less
Regulatory
UL 916 Energy Management Equipment
FCC Class A, Part 15, Subpart B and complies with Canadian ICES-003
Class B
BACnet Testing Laboratory listed as an application specific controller
SASO PCP Registration KSA R-103263
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Environmental limits
Operating 32 to 120° F (0 to 49° C)
Shipping –40 to 140° F (–40 to 60° C)
Humidity 0–95% relative humidity
(non-condensing)
Installation
Supply voltage 24 volts AC (–15%, +20%), 50-60 Hz, 12 VA, Class 2
only, non-supervised.
All circuits, including supply voltage, are power
limited circuits.
Weight Approximately 6 ounces (170 grams)
Case material Flame retardant plastic
Section 1: Introduction to the AppStat KMC Controls, Inc.
10 Revision G
To Next Page
Loading...
