34
7. Operation
7.2 Changing the profile
By default, the grinding machine produces a
profile for boiled sausage knives.
If a flatter profile is to be ground, the grinding
cycle counter must be incremented after the 2nd
feed.
The more often a knife profile is ground, the flat-
ter will be the knife.
If a short profile is to be ground, the number of
knife feeds must be reduced.
ATTENTION
Control parameters may only be changed by
accordingly qualified personnel. This person
must be familiar with the machine functions
and the meaning of the parameters. Other-
wise, damage to the machine is likely to
occur.
Figure 7-1 “Feed cycles” product data
To Next Page
Loading...