46
7.8 Changing the polishing pastes
Open the rear doors and unscrew the clamping
claw with an SW17 combination wrench (7-23/1).
Take out the polishing paste (7-23/2).
Insert new polishing paste. Screw the clamping
claw back again.
Proceed in the same way for changing the polish-
ing paste on the left (7-24/1).
Then screw the clamping claw (7-24/2) back
again.
ATTENTION
A new polishing paste must initially be
supported with a plate underneath. This
prevents the paste from breaking off. The
supporting paste must be removed as soon as
approximately half of the polishing paste has
been used up.
Tighten the clamping claw only lightly until
the pyramidal tips are pressed all the way
into the paste.
Use only original polishing pastes as the
knives will otherwise not be sharpened
properly.
7. Operation
Figure 7-24 Changing the left polishing paste
Figure 7-23 Changing the right polishing paste
1
1
2
2
To Next Page
Loading...