S008769 Rev A 7
Getting Started
4 Extender,
Feeder Table
The extender for the feeder table acts as a support mechanism for longer
documents that extend out and beyond its standard length. The extra
support allows for better feeding of document(s) into the scanner’s
transport. The extender can be pulled out to add an approximate 7.0” (18
cm) of length to the feeder table.
5 Document
Feed Guides
(Left & Right)
The document feed guides and are used to guide document(s) into the
scanner’s transport with little or no skew. They can be width adjusted
independently of one another, which allows the Operator to left, right, or
center align documents for feeding into the scanner’s transport.
6 Skimmer
Module
The skimmer (assembly) contains two rollers that assist in grabbing and
feeding documents from the feeder table into the scanner’s transport. The
skimmer assembly can be placed in an up position (manual feeding - see
2.1.1.5 Feed Modes, ‘
Manual Mode” on page 21) or a down position
(automatic document feeding - see 2.1.1.5 Feed Modes, ‘
ADF Mode” on
page 21). The skimmer rollers can get dirty and wear over time. They
require periodic cleaning and eventual replacement to maintain optimal
performance (refer to the section ‘
Maintenance” on page 57 in this manual
for more information).
7 Separator
Roller Door
Behind the separator roller door is the separator roller. The separator roller
assists in separating documents as they feed into the scanner’s transport
so as to avoid the occurrence of multifeeds. The separator roller can get
dirty and wear over time. It requires periodic cleaning and eventual
replacement to maintain optimal performance (refer to the section
‘
Maintenance” on page 57 in this manual for more information).
8 Transport
Cover Release
Levers
There are two transport cover release levers, one located on the left side of
the scanner and one on the right. The Operator is required to pull one or
both lever mechanisms towards them while standing in the front of the
scanner to release and open the scanner’s transport cover for opening in
an upward position.
9 Transport
Cover
The transport cover is a hinged cover that can be opened to access the
scanner’s transport. It opens in an upward position and will stay open in a
full up position with the support of two gas springs that are located inside
the scanner - one on either side (see Side View-2 on page 4
to view an
image of the transport cover in a full up position).
10 Document
Output Guides
(Left & Right)
The document output guides are used to guide the scanned document(s)
out of the transport into a neat stack on the exit tray
a
. They can be width
adjusted independently of one another, which allows the Operator to left,
right, or center align documents exiting the scanner’s transport, depending
on how the documents are fed into the scanner (see #5 above
)
11 Exit Deflector Hinged deflector that assists in the placement of documents in the Exit
Tray
Ref# Item Name Description
To Next Page
Loading...
