8 S008769 Rev A
Ngenuity Operator Manual
12 Exit Tray The exit tray is what the scanner ejects the document(s) into after they
have passed through the transport
b
. It is held in place by tabs located on
the back of the tray that hinge into slots found in the scanner transport
cover, directly below where documents exit. There are two different levels
of slots that assist in positioning the exit tray if needed, depending on the
types of documents being scanned.
The exit tray can be positioned in one of three ways:
Flat - Exit tray rests on top of the scanner in a flat, horizontal position, with
the tabs on the back of the tray hinged into the bottom-most row of slots in
the scanner.
Tilted Forward - Tabs at the back of the exit tray are installed in the upper-
most slots (found directly below where documents exit the scanner). This
causes the exit tray to tilt in a downward position towards the front of the
scanner. This position is conducive to forward movement which can assist
long documents exiting the scanner.
Ref# Item Name Description
Tabs
Back of Exit Tray
Top/Front View of Scanner - Exit Tray Removed
Top Row
Bottom Row
Slots-
(slide into
slots)
Stops for bracing
kickstand wire
To Next Page
Loading...
