S008769 Rev A 9
Getting Started
Tilted Backward - Tabs at the back of the tray are installed in the bottom-
most row of slots, and the hinged kickstand wire located on the bottom of
the exit tray is folded down and out. The kickstand wire is braced or
positioned against the stops found on the scanner’s upper center cover
(stops are located directly beneath the exit tray - see image above) so that
documents exiting the scanner are positioned to the back of the exit tray.
This is useful when scanning small documents such as checks.
Located beneath the exit tray is a door that allows access to the front page
imprinter (if one is installed).
NOTE
Imprinters are a user-installable option available for purchase
from BBH. See ”4.1
Imprinter” on page 53 for more information on
imprinters.
13 Guide,
Document
Stop
The document stop guide is adjustable for length and is used to stop
forward motion of the document(s) leaving the scanner’s transport. It
assists the document output guides in positioning the document(s) into a
neat stack. Pull the document stop guide out (towards the front of the
scanner) to lengthen the distance of forward motion documents travel
exiting the scanner or push the document stop guide in (towards the back
of the scanner) to shorten the distance of forward motion documents travel
when exiting the scanner.
The exit tray’s document stop guide should be placed in a down position
and not used when scanning extra long documents that require the use of
the exit tray extender (see #14
in this table).
NOTE
Positioning the document stop guide too close to the back of
the exit tray (towards the back of the scanner) can cause
documents to jam as they exit the scanner if the distance they
are allowed to travel is shorter then the length of the actual
documents themselves
c
.
Ref# Item Name Description
Kickstand Wire
(folded out)
(view from left side)
Exit Table
To Next Page
Loading...
