3. Service Mode
4
Field Service Ver.1.0 Mar. 2009
LK-101/102/103
3. Service Mode
• When using i-Option LK-101/102/103, license management is done with the following procedures. [Service
Mode] → [Billing Setting] → [License Management]
• [License Management] can set Activation/Deactivation of each i-Option functions, Repair/Initialize of func-
tions for troubleshooting, or etc.
3.1 Billing Setting function setting procedure
1.
Press the Utility/Counter key.
2.
Touch [Check Details] on meter count display.
3.
Press the following keys in this order.; Stop → 0 → 0 → Stop → 0 → 1
Note
• When selecting [CE Authentication] under [Enhanced Security] available from Service Mode,
authentication by CE password is necessary.
Enter the 8 digits CE password, and touch [END].
(The initial setting for CE password is “92729272.”)
• When the following setting is set to “ON”, CE password authentication is necessary.
[Administrator Settings] → [Security Settings] → [Enhanced Security Mode]
• If a wrong CE password is entered, re-enter the right password. The machine will not enter Service
Mode unless the CE password is entered correctly. To return to the Basic screen, turn OFF the sub
power switch and turn it ON again.
When the following setting is set to “Mode 2”, operation will be prohibited since it indicates authentica-
tion failure by failing to enter the correct CE password within the specified number of times.
if the access lock is activated, the lock release timer starts to operate by input the Stop
→
0
→
9
→
3
→
1
→
7 in [Meter Count]
→
[Check Details]
→
[Coverage Rate] after the main power switch is turned OFF
and On. When the timer reaches the time specified in this setting, the access lock is released.
• The service code entered is displayed as “✽.”
4.
The Service Mode menu will appear.
5.
Press the following keys in this order.
Stop → 9
a0pdf3e003aa
To Next Page
Loading...
Need help?
General
