2 Specification
24 © Copyright Reserved KONICS Co., Ltd.
※2. Exception range for better accuracy by sensor (Accuracy after 30min warm-up time)
R,S,C,G: 0≤T≤100 ±4.0℃,
B: No regulation accuracy below 400 ℃
T, U: -200≤T≤-100±3.0℃, -100≤T≤400±2.0℃,
CU50: -200≤T≤200±1.0℃,
DPT50: -200≤T≤500±1.5℃
※3. RS485, Ethernet communication output are not available at the same time.
※4. USB Device is available only for parameter setting.
※5. It is recommended to use shield cable to decrease noise when supplying power for
transmitter.
If connecting or disconnecting input/output card when power is ON, it may cause malfunction.
To connect or disconnect input/output card, you must turn OFF the power.
To Next Page
Loading...