KONICS krn100 - 5 Installation; Installation Place

To Next Page

To Previous Page

5 Installation

5.1 Installation place

Install this unit in place where the below conditions are satisfied.

 Place where ventilation is well

To prevent from malfunction and damage by overheating (use temperature range: 0 to 50℃),

install this unit where ventilation is well.

In case installing several KRN100, space each other by panel cut-out.

 Place where vibration is not severe

If there is too much vibration, it may cause malfunction such as print error.

For more information about vibration, please refer to ‘2 Specification’.

 In case of temperature measurement with thermocouple temperature sensor at the place

where temperature is fluctuated, data error may occur. You should warm-up this unit over 30

min. to acquire accurate data before using it.

 At the place where temperature and humidity is fluctuated excessively, recording paper

color may be changed.