EasyManua.ls Logo

KONICS krn100 - Safety Precautions

KONICS krn100
155 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety Precautions
vi © Copyright Reserved KONICS Co., Ltd.
Safety Precautions
Following these safety precautions will ensure the safe and proper use of the product and
help prevent accidents and minimize hazards.
Safety precautions are categorized as Warnings and Cautions, as defined below:
Warning
Cases that may cause serious injury or fatal accident if
instructions are not followed.
Caution
Cases that may cause minor injury or product damage if
instructions are not followed.
In case of using this unit with machinery (Ex: nuclear power control, medical equipment,
ship, vehicle, train, airplane, combustion apparatus, safety device, crime/disaster prevention
equipment, etc) which may cause damages to human life or property, it is required to install
fail-safe device.
It may cause a fire, human injury or property loss.
It must be mounted on panel.
It may cause electric shock.
Do not connect, inspect or repair this unit when power is ON.
It may cause electric shock.
Check input power specification and check power terminal number when wiring power cable.
It may cause a fire or damage by a fire.
Lithium battery is used in this product, do not disassemble or burn up this unit.
It may cause an explosion.
Do not touch the product or connect terminal within 30 sec. after turn off the power.
It may cause electric shock.
F.G. terminal should be isolation grounded. Grounded wire should be over AWG16(1.25
mm
2
).
It may cause electric shock.
Do not insert your finger or object into the vent of this unit.
It may cause electric shock or human injury.
Do not disassemble or modify this unit. Please contact us if it is required.
It may cause a fire, human injury or property loss.
This unit shall not be used outdoors.
It may shorten the life cycle of the product or cause electric shock.
When wiring power input terminal and measuring input terminal, power line should be over
AWG 20(0.50mm
2
). Terminal screw should be tightened with 0.74 Nm to 0.90 Nm torque.
Please observe the rated specifications.
It may cause shorten the life cycle of the product and cause a fire.

Table of Contents