KONICS krn100 - Page 56

8 Parameter detail setup
56 © Copyright Reserved KONICS Co., Ltd.
Parameter Set range
Factory
default
card))
Input Bias(Error correction) -999.9 to 999.9 0.0
Span (Gradient adjustment)
0.100 to 5.000
-
Record Method (Data storage method)
Instant ↔ Average ↔ Minimum ↔ Maximum
Instant
Filter Type (Input digital filter)
None ↔ Moving
None
Filter Counter (The number of digital
filter)
1 to 128 -
Burnout Action (Display setting for
break)
OFF ↔ Up_Scale ↔ Down_Scale
OFF
※Shaded parameters are affected by set value of other parameters. Please refer to specific
descriptions of each parameter.
When changing set value of
Input Type(input type)
parameter,
▶
Range/Scale Point(Decimal point position)
Display/Temp Unit(Display unit/Temperature unit)
Low Range & Graph Scale (Lower limit input value and
graph scale value)
High Range & Graph Scale (Upper limit input value and
graph scale value)
Low Scale(Analog lower limit scale value)
High Scale(Analog upper limit scale value)
Special Function (Input special function)
parameters’ set values are initialized.