Kontron CP308 - S;P-DIF-Out Interface; CD-In Interface; Internal Line-Out Mono Interface

CP308 CP308-MEDIA
ID 1027-4487, Rev. 3.0 Page B - 13
P R E L I M I N A R Y
B.6.2.3 S/P-DIF-Out Interface
Figure B-7: S/P-DIF-Out Connector J6
The CP308-MEDIA provides one S/P-DIF-Out interface
implemented on an optical fiber connector (Toslink), J6,
on the front panel. This connector is used to transmit
digital audio data, for example, via a decoder.
B.6.2.4 CD-In Interface
The CP308-MEDIA provides one CD-In interface implemented on an 4-pin onboard connector,
J9, used to connect a peripheral audio device, such as a CD-ROM.
B.6.2.5 Internal Line-Out Mono Interface
The CP308-MEDIA provides one internal line-out mono interface implemented on a 2-pin
onboard connector, J10, used to connect an audio device such as a mono active speaker with
an external load impedance of min. 10 kΩ.
Figure B-8: CD-In Connector J9
1
4
Table B-5: CD-In Connector J9 Pinout
PIN SIGNAL DESCRIPTION I/O
1 Left Left channel audio signal I
2 GND_AUD Signal ground audio --
3 Right Right channel audio signal I
4 GND_AUD Signal ground audio --
Figure B-9: Internal Line-Out Mono
Connector J10
21
Table B-6: Internal Line-Out Mono Connector
J10 Pinout
PIN SIGNAL DESCRIPTION I/O
1 Mono-Out Mono signal output O
2 GND_AUD Signal ground audio --