Introduction CP308
Page 1 - 16 ID 1027-4487, Rev. 3.0
P R E L I M I N A R Y
In addition, boards ordered with the ruggedized service comply with the following standards as
well.
1.7 Related Publications
The following publications contain information relating to this product.
Table 1-3: Additional Standards for Boards Ordered with Ruggedized Service
TYPE ASPECT STANDARD REMARKS
Environmental Vibration
(Sinusoidal)
IEC60068-2-6 Ruggedized version test parameters:
• 10-300 (Hz) frequency range
• 2 (g) acceleration
• 1 (oct/min) sweep rate
• 10 cycles/axis
•3 axis
Single Shock IEC60068-2-27 Ruggedized version test parameters:
• 30 (g) acceleration
• 9 (ms) shock duration half sine
• 3 number of shocks per direction (total: 18)
• 6 directions
• 5 (s) recovery time
Permanent Shock IEC60068-2-29 Ruggedized version test parameters:
• 15 (g) acceleration
• 11 (ms) shock duration half sine
• 500 number of shocks per direction
• 6 directions
• 51 (s) recovery time
Table 1-4: Related Publications
PRODUCT PUBLICATION
CompactPCI Systems and
Boards
CompactPCI Specification PICMG 2.0, Rev. 3.0
CompactPCI System Management Specification PICMG 2.9 Rev. 1.0
CompactPCI Hot Swap Specification PICMG 2.1 Rev. 2.0
Kontron’s CompactPCI System Manual, ID 19954
Serial ATA Serial ATA 1.0a Specification
Platform Firmware Unified Extensible Firmware Interface (uEFI) specification, version 2.1
All Kontron products Product Safety and Implementation Guide, ID 1021-9142
To Next Page
Loading...
