Introduction CP308
Page 1 - 12 ID 1027-4487, Rev. 3.0
P R E L I M I N A R Y
Interfaces
USB Eight USB ports supporting UHCI (USB 1.1) and EHCI (USB 2.0):
• Two USB 2.0 ports on the front I/O
• Two USB 2.0 ports on the rear I/O interface
• Three USB 2.0 interfaces for the onboard high-speed I/O extension con-
nector
• One onboard USB 2.0 port for the USB 2.0 NAND Flash module
Serial Two 16C550-compatible UARTs:
• COM1 available on the I/O expansion module or on rear I/O
• COM2 available on rear I/O only
Keyboard and Mouse USB keyboard and mouse support
I/O Expansion
Interfaces
I/O expansion to 8HP board version:
• 2x SATA
• Graphics ports either:
• PCIe x16 or
• SDVO (Serial Digital Video Output), HDMI (High-Definition Multime-
dia Interface), and DP (DisplayPort)
• 3x USB2.0
• 4 x1 PCIe or 1 x4 PCIe
• HDA
• PS/2
• SPI
• COM
• Monitor and control signals
Mass Storage Onboard USB 2.0 NAND Flash:
• Onboard USB 2.0 NAND Flash module supported on J14
SATA: Integrated Serial ATA Host Controllers
• Provide independent DMA operation on four ports:
• Two onboard SATA interfaces
• Two SATA interfaces switchable to rear I/O or to the 8HP expansion
module
• Data transfer rates up to 3 Gbit/s
• High-performance RAID 0/1 functionality on all SATA ports
Sockets
Front Panel Connectors • VGA: 15-pin D-Sub connector
• USB: two 4-pin, type A connectors
• Ethernet: dual RJ-45 connector
Onboard Connectors
• Two 7-pin, L-form standard SATA II connectors
• One USB 2.0 NAND Flash connector
• High-speed graphics extension connector
• High-speed I/O extension connector
• SPI extension connector
• Two 204-pin DDR3 SODIMM sockets
• CompactPCI Connectors J1 and J2
Table 1-1: 4HP CP308 Main Specifications (Continued)
CP308 SPECIFICATIONS
To Next Page
