MPS-10
-
Parameter guide
80
When a SAMPLE data file is selected
When you select a SAMPLE data file, the filename of that SAMPLE is shown (without the extension) as
“Name [ ]”.
Select “Name [ ]” and press the ENTER button to show the SAMPLE name editing screen. ( p. 24,
“Using the Name dialog box (how to change the name)”)
Move the cursor to “SAMPLE [ ]”, and specify the write destination on the MPS-10. Press the ENTER
button to show a list of SAMPLEs that are registered on the MPS-10.
Tip:
You can press the EDIT button to change the category, and you can also create new categories.
Note:
Use caution when you select an existing SAMPLE, as its data will be overwritten and the data will be lost.
To create a new SAMPLE, select “- new SAMPLE -”.
Move the cursor to “Execute” and press the ENTER button. A message is shown on the page, confirm-
ing whether you want to import the data.
Press the ENTER button to execute. Press the EXIT button to cancel.
Note:
If you cancel the operation while in progress, the SAMPLE being imported is discarded.
When a folder containing multiple SAMPLE data files is selected
After selecting the folder, specify the write destination on the MPS-10. When you select a folder, this
only specifies the category, not the SAMPLE.
Move the cursor to “Category” and press the ENTER button to show a list of categories for the SAM-
PLEs that are registered on the MPS-10.
Note:
A new category is created when you select “- new CATEGORY -”.
To Next Page
Loading...
