Kramer 348

BA 348-01 * 2.0 * 34801b340.fm 3-81
Operation 3
Removing material/digging in soft soil
☞Remove and dig as follows:
• Place the bucket horizontally on the ground B. To do this: push the control lever
forward C
• Adjust the digging angle 1. To do this: push the control lever to the right B
• Drive forward
• Set the digging angle a little flatter 2. To do this: push the control lever to the left A,
so that the layer being removed is as even as possible and so that the wheel spin is
reduced
• Proceed as for loading loose material
Fig. 108 : Lowering the loader unit to the ground
C
B
α
1
Fig. 109 : Adjusting the digging angle
1
B
Fig. 110 : Removing an even layer
2
1
A