Kramer 348

5-36 BA 348-01 * 2.0 * Aggressive Medien.fm
5 Maintenance
5.18 Maintenance “Aggressive Media” (option)
The machine is specially protected against corrosion for work in aggressive media
(a saline environment, for example).
However, this anticorrosion protection is affected by external factors, for example dirt,
cleaning, etc. This is why it only has ongoing effect if checked at regular intervals and
renewed or reapplied as required.
If no anticorrosion protection is applied to the machine, for example for work in a saline
environment, we recommend retrofitting your machine with the “Aggressive Media”
option by a sales partner.
Anticorrosion protection applied in the factory
The following anticorrosive wax has been used in the factory:
Components coated with anticorrosive wax
Designation: ANTICORIT BW 366
Manufacturer: FUCHS MINERALOELWERKE GMBH/Mannheim
Specification: TI 8030-015/K 19/MIL-C-16 173 C-Grade 4
Component Remarks
All electric plug-and-socket,
grounding and crimp connections
Before applying the wax:
• Apply contact spray to contact surfaces and
connect the plug-and-socket connections again
• Apply a particularly thick anticorrosion
layer to the connecting parts of the fuel level
transmitter
All machine parts such as axles,
gearbox, trim panels, servicing lids,
loader unit, quickhitch
Except:
• Piston rods (chromium coating)
• Cabin, cabin bearings
• Engine cover, engine mounting
• Air filter
• Counterweight
• Fastening surfaces for installing parts on frame
• Radiator and insulating mats
• Mudguards, rubber and plastic parts
• Light elements
Flange surfaces
For example axles, engine and cabin bearing:
• Seal gaps with anticorrosion wax after
assembly
Maintenance