BA 348-01 * 2.0 * 34801b340.fm 3-121
Operation 3
3.62 Putting the machine out of operation temporarily
Stopping/parking the machine
Machines parked on slopes can roll away!
☞Use the parking brake to park the machine safely and to prevent it rolling
away!
➥–seeParking brake on page 3-50
☞In addition to the parking brake, secure the machine by placing chocks
under the downhill sides of the wheels!
☞Stop the machine with the service brake
☞Set the drive to neutral with push button (Fig. 32/11) on the joystick
☞Apply the parking brake –seeParking brake on page 3-50
☞Lower the loader unit completely and set the bucket horizontally with the ground
➥–seeLoader unit control lever (overview) on page 3-64
After operation under full load:
☞Allow the engine to run for a while so that the temperature can stabilize,
then stop the engine
☞Stop the engine and remove the ignition key
➥The drive interlock option is enabled
☞Close the windows and the door as you leave the cabin
☞Close and lock the engine cover
On slopes:
☞Take additional measures to secure the machine by placing chocks under the downhill
sides of the wheels
➥The wheel chocks are stored on the machine frame behind the cabin
Putting the machine out of operation for longer time
☞If possible, retract the piston rods of the hydraulic rams to protect them against damage.
If this is not possible, apply grease to the piston rods and to the bare parts of the hydraulic
rams that are not paint-coated
☞Before putting the machine into operation, do not clean the piston rods with a
grease solvent or a high-pressure cleaner
➥The scraper is not water-tight
☞Water in the guide bushing causes corrosion and damage to the piston rod
To Next Page
Loading...
