BA 348-01 * 2.0 * 34801b340.fm 3-87
Operation 3
Setting down the multipurpose bucket
In order to avoid damage if the attachment tips over, place it on the ground
ensuring stability!
Clean the quick couplers carefully before connecting an attachment in order to
ensure correct functioning and sealing!
Furthermore, the pressure in the quick couplers has to be released before they
are connected –seePressure relief on the quick couplers and the quickhitch
on page 3-72.
The attachment is removed from the quickhitch in the same way as the
standard bucket –seeRemoving a standard bucket from the quickhitch on
page 3-75
☞Set down the multipurpose bucket as follows:
• Empty the multipurpose bucket and set it horizontally with the ground
• Stop the engine, but do not switch off ignition
• Apply the parking brake
• Release the pressure in the hydraulic lines of the 3rd control circuit
–seePressure relief on the quick couplers and the quickhitch on page 3-72
• Remove flexible lines A and B from the quick couplers of the multipurpose bucket
and insert them into the quick couplers of the quickhitch
➥ Flexible line A onto quick coupler F
➥ Flexible line B onto quick coupler E
• Close the quick couplers on the multipurpose bucket with protective caps
• Start the engine and lower the multipurpose bucket to the ground
Fig. 121 : Removing the hydraulic lines
AB
E F
To Next Page
Loading...
Need help?
General
