BA 348-01 * 2.0 * 34801b110.fm 1-17
Introduction 1
1.8 Labels and symbols
Labels on the outside of the machine
Slinging point label (eye hooks) for loading the machine
Slinging points (lifting eyes) for loading the machine or for installing/removing the cabin
– see chapter 3 “Crane-lifting the machine” on page 3-118.
Location
At the top of the cabin (4x)
Slinging point label for tying down the machine
The eye hooks are used for tying down the machine during loading and transport.
Other information – see chapter 3 “Loading and transporting the machine on a transport
vehicle” on page 3-119
Location
On the left and right of the machine frame above the front axle attachment, and at the rear
underneath the engine
Noise level label
Noise level produced by the machine.
L
WA
= sound power level
Other information – see chapter 6 “Noise levels” on page 6-10
Location
On the rear window/on the control stand
Label: maximum design-specific speed
Design-specific max. machine speed is 20 kph.
Location
At the rear and at the rear left/right of the machine
Label: indication of danger.
This label alerts persons standing or working near the loader to an existing hazard within
the area around the machine.
Location
Front left and right of machine frame, and at rear of machine.
Label: do not open the engine cover
Do not open engine cover before engine is at a standstill!
Do not touch any turning parts!
Location
On the engine cover of the machine
Fig. 11 : Label for points used for tying down the machine
Fig. 12 : Noise level label
Fig. 15 : Prohibitory label
To Next Page
Loading...
