BA 348-01 * 2.0 * 34801b330.fm 3-47
Operation 3
3.27 Low-speed control (option)
Setting the travel speed with the low-speed control
Control lever B of the low-speed control is located at the left of the centre console.
The travel speed can be set continuously and independently of the engine speed with
control lever B of the low-speed control.
This function corresponds to inching with the brake/inching pedal.
This function is especially useful for operation of hydraulically driven attachments
(rotary broom, rotary hoe, for example) in order to ensure continuous travel speed.
Risk of death. Risk of accidents.
There is risk of death when leaving the machine with the low-speed control
switched on at the same time.
☞Never leave the machine during machine operation!
In an emergency situation, immediately press the brake/inching pedal and
push control lever B backward to the limit O!
In order to avoid risk of accidents, push control lever B backward to the limit
O before starting the diesel engine again!
☞Sit down on the operator seat
☞Select the travel direction
–seeChanging direction (forward/reverse) on page 3-51
–seeChanging direction (forward/reverse) on page 3-51
☞Set constant engine speed with the accelerator pedal or the manual throttle (option)
☞Select the required travel speed with control lever B
➥ Limit M – maximum speed
➥ Limit O – machine is at a standstill
When equipped with a canopy (option), the machine is fitted with an operator
presence switch.
The diesel engine is stopped after 3 – 4 seconds if the operator stands up from
the seat with the engine running.
Fig. 67 : Low-speed control (option)
B
O
M
To Next Page
Loading...
