Kramer 348

2-10 BA 348-01 * 2.0 * Sicherheit_Radlader.fm
2 Safety instructions
2.5 Safety instructions for maintenance
• Avoid any operational mode that might be prejudicial to safety!
• Observe the adjustment, maintenance and inspection activities and intervals set forth in the
Operator’s Manual, including information on the replacement of parts/partial equipment!
These activities may be performed by technical personnel only!
• The machine may not be serviced, repaired or test-driven by unauthorized personnel!
• Brief operating personnel/operator before beginning special operations and maintenance!
Appoint a person to supervise the activities!
• In any work concerning the operation, conversion or adjustment of the machine and
its safety-oriented devices, or any work related to maintenance, inspection and repair,
observe the start-up and shut-down procedures set forth in the Operator’s Manual, and
the information on maintenance.
• If required, secure the maintenance area appropriately!
• Prior to performing service, maintenance and repair work, attach a warning label, such
as “Repair work – do not start machine!”, to the ignition lock/steering wheel or to the
control elements.
Remove the ignition key!
• Perform service, maintenance and repair work only if
• the machine is positioned on firm and level ground
• the drive is in neutral
• the parking brake is applied
• all hydraulically movable attachments and working equipment have been lowered to
the ground
• the engine is stopped
• the ignition key is removed and the
• the machine has been secured against unintentional movement!
• Should maintenance or repair be inevitable with the engine running:
• Only work in groups of two
• Both persons must be authorized for the operation of the machine
• One person must be seated on the operator seat and maintain visual contact with the
other person
• Observe the specific safety instructions in the work manual
• Keep a safe distance from all rotating and moving parts, for example fan blades,
V-belt drives, PTO shaft drives, fans, etc.!
• Prior to performing assembly work on the machine, ensure that no movable parts will
roll away or start moving!
• To avoid the risk of accidents, parts and large assemblies being moved for replacement
purposes must be carefully attached and secured to lifting gear.
Use only suitable lifting gear and suspension systems in a technically perfect state with
adequate load-bearing capacity!
Stay clear of suspended loads!
• The brake and steering systems are crucial to safety. Maintenance must be
performed by trained personnel and an authorized service centre only!