3-32 BA 348-01 * 2.0 * 34801b330.fm
3 Operation
Putting the drive interlock out of operation
We recommend putting the drive interlock out of operation if the machine has to stay in a
service centre, for example, or if the machine does not require any protection. This avoids
having to communicate the code.
1 Disable the system by entering the personal or main code and by confirming with the (*) key
2 Turn the ignition key to position 1
➥The LED illuminates for 2 seconds
3 As soon as the LED goes out, press the (*) push button for about 2 seconds until a short
acoustic signal, followed by two further signals, sounds
➥The LED now flashes very slowly, and the keypad is disabled
4 Turn the ignition key to 0 and remove it
5 The engine can be started without entering the code. The system is out of service even
if electric power is interrupted.
If the system is out of operation, the LED flashes slowly even if the ignition key
is in position 1.
☞Entering the personal or main code does not have the effect of putting the
system back into operation again (the acoustic signals for confirmation are
still given). See the following procedure for putting back into operation
again, to leave the out-of-operation status again
Putting the drive interlock back into operation again
☞Press the (*) key for 2 seconds (ignition key in position 0) until two short acoustic signals
are given for confirmation
➥The system is enabled again. The code must be entered to start the engine.
Interruption of drive interlock power
If the drive interlock was enabled before electric power was interrupted, short acoustic signals
are given upon switching on the keypad (similar to those that are given when entering the wrong
code four times). In this case, wait until the acoustic signals are no longer given. Then disable
the drive interlock with the personal or main code.
The LED still does not illuminate if the drive interlock was disabled. The engine can be
started before the LED starts flashing again.
If the drive interlock was out of operation, this status remains unchanged and the LED
flashes slowly.
Drive interlock maintenance
The drive interlock does not require any maintenance.
Protect the keypad and the control unit from heat and humidity.
To Next Page
Loading...
