3-82 BA 348-01 * 2.0 * 34801b340.fm
3 Operation
Removing material/digging in hard soil
☞Remove and dig as follows:
• Lower the bucket horizontally to the ground 1. To do this: push the control lever
forward C
• Adjust the digging angle flatter 1 than for digging in soft soil. To do this: push the
control lever to the right B
• Travel forward and press the bucket downward a little as you do so. To do this: push
the control lever forward C a little
Once the bucket has penetrated the soil:
• Set the digging angle a little flatter 1. To do this: push the control lever to the left A,
so that the layer being removed is as even as possible and so that the wheel spin is
reduced
• When the machine moves forward, move the control lever quickly to the left and right
A and B to loosen the material
• Proceed as for loading material hard to penetrate
Grading
☞Grade as follows:
• Lower the loader unit horizontally to the ground 1
• Reverse across the surface to be graded 2
Loading heaped material (non-compacted material)
☞Proceed as follows:
• Set the blade parallel to the ground. To do this: push the control lever to the left or
right A and B
• Lower the loader unit horizontally to the ground. To do this: push the control lever
forward C
• Drive forward
• After penetrating the heaped material:
• Raise the loader unit evenly. To do this: pull the control lever backward D
• Tilt in the bucket. To do this: push the control lever to the left A
• Reverse out of the material
• Lower the loader unit to transport position
Fig. 111 : Removing hard soil
2
1
C
A
B
Fig. 112 : Adjusting the digging angle flatter
1
A B
Fig. 114 : Penetrating heaped material
C
A
B
D
Fig. 115 : Reversing away from heaped material
1
To Next Page
Loading...
