Kramer 348

BA 348-01 * 2.0 * 34801b520.fm 5-43
Maintenance 5
Other inspection work ( ) :
• Check the fuel/water separator. Drain water if necessary
●●
• Check valve clearance (engine management). Set if necessary
●●
• Check battery charge condition, charge the battery if necessary
●
●●
• Heating: clean the fine-dust filter, replace it if necessary
6
●●●
• Check and adjust the parking brake, replace if necessary
●●●
• Tyre check (damage, inflation pressure, tread depth)
●
● ●●●●
• Aggressive media (option):
check anticorrosion protection, renew if necessary
● ●●●
Check screws and nuts or threaded fittings for tightness on the following assemblies/components. Retighten if necessary
• Engine and engine bearing
●●●
• Steering system, steering ram fastening
●●●
• Check the hydraulic system for leakage
●●●
• Loader unit (pin locking)
●●●
• Axle mounting, axle suspension
●●●
• Counterweight (attachment)
●●●
• Fastening screws of cabin or canopy (option)
●●●
• Wheel nuts
●
●●●
• Fastening screws of trailer coupling (option)
●
●●●
• Electrical system: check electric and ground connections,
chafing on wiring harness, battery terminals
●
●●●
Lubrication service ( ):
9
• Hinges, joints and fittings (for example door arresters)
●●●●
• Rear axle oscillating bearing
10
● ●●●●
• Front/rear axle wheel motor bearings (8x)
10
● ●●●●
• Trailer coupling – joint (option)
●
●●●●
• Loader unit – see chapter 5 “Lubrication work on the loader unit” on page 5-19
• Lift frame bearing ●
●●●●
• Quickhitch: bearing on lift frame ●
●●●●
• Tilt rod bearing ●
●●●●
• Tilt lever bearing ●
●●●●
• Lift ram bearing ●
●●●●
• Tilt ram bearing ●
●●●●
Work description
1
Service
centre
User/operator
Service centre
Delivery
inspection
Maintenance
(once a day)
Every 50 o/h
“A”
1st Inspection
at 100 o/h
2
“B” every
500 o/h
2
“C” every
1500 o/h
once a year