Krone Big Pack 1270 - Page 112

Commissioning
112
Pos: 97.31 /BA/Ers tinbetriebna hme/Gelenkwelle/ Großpacken pressen/Gelenkwelle ByPyMit in nerer Schmierleit ung @ 170\ mod_136972 8863034_78.doc x @ 1467827 @ @ 1
With inner lubrication line
The inner lubrication lines may be cut when shortening the section tube inside. If this is
the case, the lubrication lines must be removed and adjusted and a new access hole
must be drilled.
4mm
a
a
a) b)
c) d)
Fig.
53
1)
Section tube inside
2)
Grease nipple
3)
Lubrication line (I)
4)
Separated section tube inside
5)
Roll pins
6)
Lubrication line (II)
7)
End piece
• Screw out the grease nipple and pull the lubrication line (I) out of the section tube.
• Shorten the lubrication line (I) by a = 5 cm.
From the separated section tube
• Tap out the roll pins to the inside.
• Pull the lubrication line (II) out of the section tube and remove the end piece.
• Attach the end piece onto the shortened lubrication line (I).
Drill a bore hole Ø 4 mm with a distance of a = 5 cm into the section tube, top and bottom.
Make certain the bore holes and the bore hole of the grease nipple are on the same side.
• Insert the lubrication line, screw in the grease nipple and drive in the roll pins.
Pos: 97.32 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1