Krone Big Pack 1270 - Page 113

Commissioning
113
Pos: 97.33 /BA/Ers tinbetriebna hme/Gelenkwelle/ Großpacken pressen/Gelenkwelle ByPyGel enkhälften m ontieren @ 170\ mod_136972 8798111_78.doc x @ 1467799 @ @ 1
Installing the PTO shaft halves
Fig.
54
Inner PTO shaft half Outer PTO shaft half
1)
Section tube inside
2)
Raceway inside
3)
Fastening screw
4)
Guard tube inside
5)
Guard tube outside
6)
Protective sleeve
7)
Section tube outside
8)
Raceway outside
9)
Slide ring
10)
Retaining spring
Inner PTO shaft half
• Grease the raceway seat.
• Insert the raceway inside into the groove.
• Slide on the protective tube inside and secure with fastening screws.
Outer PTO shaft half
• Grease the raceway seat and the slide ring seat.
• Insert the raceway outside into the groove.
• Position the slide ring and hook the retaining spring in place in the both bore holes of the
slide ring.
• Slide on the protective sleeve and secure with fastening screws.
• Slide on the protective tube outside and secure with fastening screws.
Pos: 97.34 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1