Krone Big Pack 1270 - Page 528

9 Terminal – menus [Medium Plus/Comfort Plus Electronics]
9.16 Alarm messages
84
Supplement to Operating Instructions 150000773_00_en
BiG Pack 1270, BiG Pack 1270 XC, BiG Pack 1290, BiG Pack 1290 HDP, BiG Pack 1290 HDP XC, BiG Pack
1290 XC, BiG Pack 890, BiG Pack 890 XC
9.16 Alarm messages
WARNING
Personal injuries and/or machine damage caused by non-observance of alarm
messages
When alarm messages are ignored and the malfunction is not remedied, personal injuries
and/or serious damage to the machine could result.
 When alarm message is displayed, remedy the malfunction, refer to page84.
 If the malfunction cannot be remedied, contact KRONE customer service.
KMC - 522064- 7
EQG000-034
The display shows an alarm message if a malfunction occurs on the machine. At the same time
an audio signal will be heard (continuous horn sound). Description, possible cause and remedy,
refer to page84.
Acknowledging the alarm
 Press
.
Æ The acoustic signal stops.
If the malfunction occurs again, the alarm message will also appear again.
9.16.1 Error Messages
Components may be repaired or replaced by a qualified service centre only. Contact your
dealer.
Before you contact your dealer, collect information about the error by
• noting down the error number.
• Visually check the sensor/actuator, refer to page84
• If an actuator is defective, run an actuator test to identify the status of the actuator, refer to
page81.
• If a sensor is defective, run a sensor test to identify the status of the sensor, refer to
page74.
The more information you give your dealer, the easier it is to eliminate the cause of the error.
Performing visual inspection
ü The machine is shut down and safeguarded, refer to page21.
 Check sensor/actuator externally for damage.
 Check connector cable and plug connection for damage and tight fit.