Safety 2
Basic safety instructions 2.3
Original Operating Instructions 150000802_00_en 21
Hot liquids
If hot liquids are drained, people may burn and/or scald themselves.
When draining hot consumables, wear personal protective equipment.
Before performing any repair, maintenance or cleaning work, allow liquids and machine
parts to cool off, if necessary.
Damaged compressor unit
Damaged compressed air hoses of compressor unit may tear off. Hoses that move
uncontrollably may hurt people seriously.
If it is suspected that the compressor unit is damaged, immediately contact a specialist
workshop.
Shut down and safeguard the machine, refer to page23.
Hot surfaces
The following components may become hot during operation:
• Transfer gearbox
• Mower gearbox
• Belt gearbox
• Hydraulic system
• Cutter bar
Maintain a sufficient distance from hot surfaces.
Allow machine parts to cool down and wear protective gloves.
2.3.18 Dangers in connection with certain activities: Working on the machine
Only perform work when the machine is at standstill
If the machine is not shut down and safeguarded, parts may move unintentionally or the
machine may start moving. Thus there is a risk of serious injuries or death.
Before carrying out any repair, maintenance and cleaning work on the machine, shutdown
and safeguard it, refer to page23.
Maintenance and repair work
Improper maintenance and repair work endanger operational safety. Thus there is a risk of
accidents, serious injuries or death.
Only perform work which is described in this operating instructions. Prior to any work, stop
and safeguard the machine, refer to page23.
All other maintenance and repair work must only be performed by qualified specialist
workshop.
To Next Page
Loading...
Need help?
General
