Krone EasyCut F 320 - Maintenance - Every 10 Hours, but at Least Once a Day; Maintenance - Every 50 Hours; Maintenance - Every 200 Hours

11 Maintenance - General Information
11.1 Maintenance table
54 Original Operating Instructions 150000802_00_en
Components
Check/replace retaining bolt (blade quick
fastener)
refer to page70
Check/replace blade carrier (blade quick
fastener)
refer to page70
Check/replace linings on cutterbar refer to page72
Vent friction clutch refer to page58
Check guard cloths refer to page59
Tighten screws/nuts refer to page55
11.1.3 Maintenance - Every 10 hours, but at least once a day
Checking oil level
Main gearbox refer to page61
Mower gearbox refer to page62
Cutterbar refer to page63
Components
Check/replace blades refer to page67
Check/replace cutting discs/mower drums refer to page71
Check/replace retaining bolt (blade screw con-
nection)
refer to page70
Check/replace retaining bolt (blade quick
fastener)
refer to page70
Check/replace blade carrier (blade quick
fastener)
refer to page70
Check guard cloths refer to page59
11.1.4 Maintenance - Every 50 hours
Components
Tighten screws/nuts refer to page55
11.1.5 Maintenance - Every 200 hours
Changing the oil
Main gearbox refer to page61
Mower gearbox refer to page62
Cutterbar refer to page63