Storage 16
Original Operating Instructions 150000802_00_en 77
16 Storage
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
To avoid accidents, the relevant safety instructions must be read and observed, refer to
page12.
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
The safety routines must be read and observed to avoid accidents, refer to page23.
Placing the machine in storage at the end of the harvest season is the best possible way to
preserve the machine.
Park the machine in a weatherproof and dry place which is far away from corrosive
substances.
Clean the machine thoroughly.
Chaff and dirt attract moisture which causes steel parts to start rusting.
NOTICE
Damage to the machine due to water damages with high-pressure cleaner
If the water jet from a high-pressure cleaner is aimed directly at bearings and electrical/
electronic components, these parts can be damaged.
Do not aim the water jet from high-pressure cleaner at bearings and electrics/electronic
components.
Lubricate the machine according to lubrication chart. Do not wipe off any grease that comes
out of bearing points as the hardened grease will provide additional protection against
moisture.
Grease the threads of setting screws and similar items.
Relieve the relief springs.
Disassemble the universal shaft. Grease the inner tubes.
Grease the grease nipples on the universal joint of the universal shaft and on the bearing
rings of the guard tubes, refer to page74.
INFORMATION
Observe operating instructions of universal shaft manufacturer.
Lubricate the uncoated piston rods of all hydraulic cylinders liberally and insert as far as
possible.
Wet all lever joints and bearing positions, which cannot be lubricated, with oil.
Repair places with damaged paint and preserve all bare metal places thoroughly with rust
protection agent.
Check all moveable parts to make certain they move easily. If necessary, dismount, clean,
grease and remount.
If parts need to be replaced, use only KRONE original spare parts.
To Next Page
Loading...
Need help?
General
