13 Maintenance - Gearbox
13.3 Oil change and oil level check on the cutterbar
64 Original Operating Instructions 150000802_00_en
Aligning cutterbar in transverse direction (direction of travel)
Place the spirit level (1) diagonally on the cutterbar.
Align the cutterbar using the spirit level(1), if required re-adjust using the cutting height
setting, refer to page51.
Aligning the cutterbar in longitudinal direction
Place the spirit level (1) on two cutting discs.
Align the cutterbar using the spirit level (1); align it horizontally using wedges, if necessary.
KM000-036
Release the locking screw of the inspection hole (1).
ð The oil level must reach up to the inspection hole (1).
If the oil reaches the inspection hole (1):
Mount the locking screw of the inspection hole (1),refer to page57.
If the oil does not reach the inspection hole (1):
Top up new oil via the inspection hole (1) up to the inspection hole (1).
Mount the locking screw of the inspection hole (1),refer to page57.
>>>
2 Setting the cutting height [}51]
To Next Page
Loading...
