Krone Fortima F 1250 MC - Menu 2 “Number of Twine Layers” (Twine Tying)

Terminal – Menus
153
Pos: 45.28.7 /Überschr iften/Überschr iften 3/K-O/M/Menü 2 "Anzah l Garnlagen" (Garnbi ndung) @ 356\mod_143867 8595637_78.docx @ 265203 5 @ 3 @ 1
14.7.2 Menu 2 “Number of Twine Layers” (Twine Tying)
Pos: 45.28.8 /BA/I nfo-Center/ALLE Termina ls in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundballen pressen/Menü 2 Anzahl Garnlagen_Bild_ALLE Terminals_Fortima @ 384\mod_1444645158360 _78.docx @ 2758588 @ @ 1
IBT000226
+
-
n
IBT000032
2.5
n
n
n
2.0
Fig. 108
Pos: 45.28.9 /BA/I nfo-Center/ALLE Termina ls in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundballen pressen/Menü 2 Anzahl Garnlagen_Text_ALLE Ter minals_Comprima F V_For tima @ 384\mod_14446489 29239_78.docx @ 2758686 @ @ 1
Prerequisite
– The menu level is called, refer to chapter entitled Terminal - Menus, “Calling the Menu
Level”.
– In menu 8 “Selection Type of Tying”, twine tying is selected,
refer to chapter Terminal – Menus, “Menu 8 ‘Selection Type of Tying’”.
• Select
n
to open the menu.
The display shows menu 2 “Number of Twine Layers”.
Setting twine layers
The following functions can be set:
Icon Explanation
n
Inject twine layers.
n
Cut off twine layers.
• Increase or reduce the value, refer to chapter entitled Terminal - Menus “Changing Value”.
• Save value.
Pos: 45.28.10 /Layout Module /---------------Seitenumbruch------------- --- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1