Krone Fortima F 1250 MC - Central chain lubrication system

Settings
260
Pos: 51.43.1 /Überschr iften/Überschr iften 2/U-Z/ZZentra le Kettenschmierung @ 33\ mod_1254819776816_78. docx @ 319945 @ 2 @ 1
17.2 Central chain lubrication system
Pos: 51.43.2 /BA/Ei nstellungen/Rundbal lenpresse/Zentr ale Kettenschmierung @ 33\ mod_1254819918129_ 78.docx @ 319966 @ @ 1
1
2
3
RBV05150
Fig. 213
The central chain lubrication system is attached to the left-hand side of the machine behind the
front guard.
Each time the drive shaft makes a rotation, oil is forced out of the tank (1) via the pump (2) and
the lubrication manifolds attached to the left-hand and right-hand side of the machine, and onto
the brushes on the drive chains.
Different nozzles are built into the lubrication manifolds for each lubrication point.
The delivery rate can be adjusted by means of the eccentric cam (3) on the drive roller.
6
7
8
128 mm
VP-2-001
1
2
Fig. 214
• Loosen the screws (2).
• Rotate the eccentric cam disc (1).
• Retighten the screws (2).
Pos: 51.43.3 /BA/Ei nstellungen/Rundbal lenpresse/Exzent erscheiben @ 55\mod_12922 36108625_78.doc x @ 518264 @ @ 1
Position of excenter discs:
• Excenter disc (1) on marking (1) correspondents little oil
• Excenter disc (1) on marking (8) correspondents much oil
Check dimension 128 mm and adjust if necessary.
Note
The amount of oil has to be adjusted to the outside temperature and the harvesting conditions.
The chains have to be lubricated sufficiently.
Pos: 51.43.4 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.d ocx @ 4165 @ @ 1