Krone Fortima F 1250 MC - Display Central Chain Lubrication System

Settings
263
Pos: 51.43.9 /Überschr iften/Überschr iften 3/P-T/SSchaubi ld zentrale Kettensc hmierung @ 233\mod_1394 001446355_78.docx @ 1860205 @ 3 @ 1
17.2.1 Display Central Chain Lubrication System
Pos: 51.43.10 /Abkürzu ngen /Abkürzungen spr achneutral/Rundba llenpressen/Forti ma F 1250 (MC) / F 1600 (MC) @ 113\mod_133 8372324634_78.doc x @ 1001105 @ @ 1
Fortima F 1250 (MC) / Fortima F 1600 (MC)
Pos: 51.43.11 /BA/Ei nstellungen/Rundba llenpresse/Schaubi ld zentrale Kettensc hmierung Fortima F1250 ( MC), F1600 (MC) @ 233\mod_1 394001087184_78.doc x @ 1860118 @ @ 1
FOR00035
Fig. 217
a Floor conveyor
b Starter roller
c Spur wheel
d Cutting system drive
e Pick-up drive
f Pick-up
g Main drive
Pos: 51.43.12 /BA/Ei nstellungen/Rundba llenpresse/Zahle n in Klammern geben die Größe der Düsen an @ 233\mod_1394002 051424_78.docx @ 1860340 @ @ 1
The figures in the brackets state the size of the nozzles for the individual lubrication points.
Pos: 51.43.13 /BA/Ei nstellungen/Rundba llenpresse/Hin weis - Beim Auswechseln der Düsen di e richtige Größe ver wenden @ 233\mod_13940012781 60_78.docx @ 1860176 @ @ 1
Note
Make certain the correct sizes are used when changing the nozzles. Each size difference
doubles the oil delivery rate (MM4 deliveres for example twice as much oil as MM3).
Pos: 51.43.14 /Layout Module /---------------Seitenumbruch------------- --- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1