Krone Fortima F 1250 MC - Menu 9 “Correction Filling“ (Fortima V 1500 (MC))Menus: Correction Filling

To Next Page

To Previous Page

Terminal – Menus

159

Pos: 45.28.37 /Übersc hriften/Überschr iften 3/K-O/M/Menü 9 „ Korrektur Befüllung" ( Fortima V 1500 (MC), V 1800 ( MC)) @ 384\mod_1444652286711_ 78.docx @ 2759151 @ 3 @ 1

14.7.8 Menu 9 “Correction Filling“ (Fortima V 1500 (MC))Menus: Correction Filling

Pos: 45.28.38 /BA/I nfo-Center/ALLE Termina ls in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundballe npressen/Menü 1- 9_9 Korrektur Befüllung_Ei nleitung_ALLE Ter minals_Comprima V CV_+X- treme_Fortima @ 389\mod_1 445426083435_78.d ocx @ 2781847 @ @ 1

If bale diameter is not reached or if it is too large, it can be corrected in a predefined range

(bale size -10 to +10 cm) by means of correction filling.

Pos: 45.28.39 /BA/I nfo-Center/ALLE Termina ls in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundballe npressen/Menü 9 Kor rektur Befüllung_Bil d_ALLE Terminals_Forti ma V @ 384\mod_144465240998 8_78.docx @ 2759182 @ @ 1

IBT000225

IBT000212

-10

0 cm

Fig. 114

Pos: 45.28.40 /BA/I nfo-Center/ALLE Termina ls in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundballe npressen/Menü 9 Kor rektur Befüllung_Text_ ALLE Terminals_Compr ima V_+X-treme_Forti ma @ 384\mod_144465254072 3_78.docx @ 2759209 @ @ 1

Prerequisite

– The menu level is called, refer to chapter entitled Terminal - Menus, “Calling the Menu

Level”.

• Select

to open the menu.

The display shows menu 9 “Correction Filling”.

Setting the correction filling

• Increase or reduce the value, refer to chapter entitled Terminal - Menus “Changing Value”.

• Save value.

Pos: 45.28.41 /BA/I nfo-Center/ALLE Termina ls in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundballe npressenMenü 1-9_9 Kor rektur Befüllung_Te xt2-Beispiel_ALLE Terminals_Comprima V CV_+ X-treme_Fortima @ 403\ mod_1448286147142_78. docx @ 2854583 @ @ 1

Example

The set target bale diameter is 108 cm.

If the actual bale diameter is only 100 cm, which is 8 cm too small, a correction value of +8 cm

must be set.

This means:

Correction value = target bale diameter - target diameter

Pos: 45.28.42 /Layout Module /---------------Seitenumbruch------------- --- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1