Krone Fortima F 1250 MC - Adjusting the Automatic Floor Conveyor Stop

Settings
265
Pos: 51.45 /Übersc hriften/Überschri ften 2/A-E/EEinstel lung der automatischen Rollbodenabschaltun g @ 116\mod_1341208553537 _78.docx @ 1021010 @ 2 @ 1
17.3 Adjusting the Automatic Floor Conveyor Stop
Pos: 51.46 /Abkürzun gen /Abkürzungen sprac hneutral/Rundbal lenpressen/Fortim a V 1500 (MC) / V 1800 (MC)_sprachneu tral @ 226\mod_13927208 27776_0.docx @ 1826878 @ @ 1
Fortima V 1500 (MC) / V 1800 (MC)
Pos: 51.47 /BA/Einste llungen/Rundball enpresse/Bild Rol lbodenabschaltung eins tellen @ 74\mod_13092 41717975_78.docx @ 660349 @ @ 1
VP-7-075
a
1
4
2
6
5
3
Fig. 219
Pos: 51.48 /BA/Einste llungen/Rundball enpresse/Rollbode nabschaltung einst ellen @ 74\mod_13092431097 95_78.docx @ 660377 @ @ 1
When the tailgate is opened, the claw coupling (4) is activated by the cable (1) and linkage (2)
and the floor conveyors are switched off.
When switched on, dimension a to the side wall (6) must be approximately 22 mm.
Setting:
• Loosen the counter nut (3).
• Remove the bolt.
• Turn the U bar (5) until dimension a is reached.
• Install the bolt and counter net and retighten.
Pos: 51.49 /BA/Einste llungen/Rundball enpresse/Bild Scha lteinstellungen @ 74\ mod_1309243333386_78. docx @ 660445 @ @ 1
VP700025
Fig. 220
Pos: 51.50 /BA/Einste llungen/Rundball enpresse/Schalteins tellung @ 74\mod_130 9243498008_78.doc x @ 660473 @ @ 1
The pressing force of the spring by the pull cable can be adjusted with the nuts (2).
When the tailgate is closed, dimension b must be approximately 250 mm.
To adjust switching, follow these steps:
• When the rear wall is closed, tension on the cable (3) must be slightly relieved and the
claws must be engaged. The cable length can be adjusted on the bar (4).
• With the rear wall slightly opened, adjust the nut (1) so that the roller (5) closes off flush with
the tip of the slotted link (6).
Note
The tip of the slotted link (6) must not be under the roller (5) when the rear wall closes.
Pos: 51.51 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1