Maintenance
268
Pos: 53.8 /Überschri ften/Überschri ften 2/U-Z/W/Wartungs tabelle @ 65\mod_13003694 13064_78.docx @ 583966 @ 2 @ 1
18.2 Maintenance table
Pos: 53.9 /BA/War tung/Rundballenpress e/Wartungstabellen/ Tabelle Wartungsarbei ten_Fortima F1250 ( MC), F1600 (MC), V1500 (MC), V1800 (MC) @ 510\mod_150167586 1513_78.docx @ 3497510 @ @ 1
Maintenance interval Machine Part
Oil change
Check
Adjustment
Venting
Retightening
After the first 8 operating
hours and each time a wheel
is changed
Wheels, wheel nuts
X
After extended downtimes Friction clutch of the universal shaft
X
After first use and then after
every 100 bales
Chain tension of bale formation
conveyor drive
X X
Chain tension of pick-up drive
X X
Chain tension bale formation
conveyor (Fortima
F 1250 (MC)/F 1600 (MC))
X X
At the beginning of the
season (after approx. 5
bales)
Chain tension of bale formation
conveyor drive
X X
Chain tension of pick-up drive
X X
Chain tension of roller drive
X X
Every 500 operating hours
Gearbox
After every season
Pos: 53.10 /BA/W artung/Hinweis Verschleiß verringern @ 0\mod_119 9953505303_78.doc x @ 37204 @ @ 1
Note
To ensure problem-free operation of the machine and to reduce wear and tear, specific
maintenance and upkeep intervals must be observed. These include cleaning, greasing,
lubricating and oiling parts and components.
Pos: 53.11 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
