Terminal – Menus
175
Pos: 45.28.116 /Übersc hriften/Übersc hriften 3/K-O/M/Menü 15- 2 "Aktortest" @ 360\mod _1439362622356_78.doc x @ 2665666 @ 3 @ 1
14.7.21 Menu 15-2 “Actuator Test”
Pos: 45.28.117 /BA/Si cherheit/7. Gefahr enhinweise alt/W ARNUNG - Aktortest @ 301\mod_1413441650591_ 78.docx @ 2349581 @ @ 1
WARNING!
The functions are directly executed by energizing the actuators. As a result, machine
parts may start to move unexpectedly, persons may be captured and seriously hurt.
• Switch off PTO shaft.
• Deactivate tractor hydraulics.
• Only persons familiar with the machine are permitted to perform the actuator test.
• The person performing the test must know the machine parts being actuated by controlling
the actuators. If necessary, secure actuated machine components from unintentional
lowering.
• Only perform the sensor test from a safe position outside the moving machine parts.
• Make sure that there is no one in the danger zone.
Pos: 45.28.118 /BA/I nfo-Center/Großpac kenpresse/Hauptmen üs/Hauptmenü 4 Ser vice/Menü 4-4 Aktortest Hand Ac htung @ 44\mod_12756379 29203_78.docx @ 393455 @ @ 1
CAUTION! - Unexpected actions on the machine.
The P.T.O. shaft must not be turning during the actuator test. The tractor hydraulics must be
deactivated.
Pos: 45.28.119 /BA/I nfo-Center/Großpac kenpresse/Hauptmen üs/Hauptmenü 4 Ser vice/Menü 4-4 Aktortest Hand Ei nführungstext @ 361\ mod_1439385831649_78. docx @ 2667086 @ @ 1
The actuator test is used to test the actuators installed on the machine. An actuator can only be
tested when it is powered. Therefore the actuator must be controlled manually for a short time in
the actuator test in order to determine possible errors in the actuator system.
Pos: 45.28.120 /BA/I nfo-Center/ALLE Ter minals in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundba llenpressen/Menü 15- 2 Aktortest_Bild_ALLE Terminals_Fortima @ 385\mod_1444742257766 _78.docx @ 2760265 @ @ 1
IBT000049
IBT000231
Fig. 127
Pos: 45.28.121 /BA/I nfo-Center/ALLE Ter minals in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Übergrei fend über alle Maschine n/Menü 15-2 Aktortest _Text_ALLE Terminals @ 377\ mod_1443081897423_78. docx @ 2735775 @ @ 1
Prerequisite
– Menu “Settings” is called, refer to chapter Terminal - Menus, “Menu 15 ‘Settings’”.
• Select to open the menu.
The display shows menu 15-2 “Actuator Test”.
Selecting the Actuator
• Use and to navigate through the displayed actuators and select the desired
actuator.
The selected sensor is grey shaded.
Pos: 45.28.122 /Layout Module /------ ---------Seitenumbruc h---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
