Commissioning
78
Pos: 31.27 /Übersc hriften/Überschri ften 2/F-J/HHöhenanpa ssung der Deichsel @ 17\mod_1 236255816988_78.doc x @ 204061 @ 2 @ 1
7.3 Adjusting the drawbar height
Pos: 31.28 /BA/Er stinbetriebnahme/Rundba llenpresseAnpa ssen des Reifenluftdruc ks Rundballenpres sen @ 114\mod_1338881601 674_78.docx @ 1006469 @ @ 1
Note
Before aligning the machine and adapting the height of the drawbar, the tyre pressure must be
checked and adapted to the value for the existing tyre type which is recommended in the tyre
air pressure table (refer to chapter entitled “Maintenance”), if necessary.
Pos: 31.29 /BA/Er stinbetriebnahme/Rundba llenpresse/Deic hselhöheDeichse lhöhe anpassen_Forti ma @ 244\mod_1395761594338 _78.docx @ 1908344 @ @ 1
RBV0425A_1
X
Fig. 36
Note
To guarantee optimum working, the machine has to be hitched in a way that the dimension X is
approx. 530 mm. The dimension
X is measured from the ground up to the middle of the lower
head of the screw and has to be adjusted to the respective harvesting conditions as well as the
tyre size.
To Next Page
Loading...
