Terminal – Menus
169
Pos: 45.28.88 /Übersc hriften/Überschr iften 3/K-O/M/Menü 14- 5 „TIM-Software konf igurieren" @ 392\mod_1446 185379819_78.doc x @ 2807876 @ 3 @ 1
14.7.17 Menu 14-5 “Configurate TIM Software (for version with “TIM”)
Pos: 45.28.89 /BA/I nfo-Center/ALLE Termina ls in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundballe npressen/Menü 14- 5 TIM-Software konfiguri eren_Bild_ALLE Terminals_Fortima @ 392\mo d_1446185692173_78. docx @ 2807907 @ @ 1
IBT000229
TIM
IBT000238
TIM
2
50%
STOP
Fig. 123
Pos: 45.28.90 /BA/I nfo-Center/ALLE Termina ls in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundballe npressen/Menü 14- 5 TIM-Software konfiguri eren_Text1-Voraus s_ALLE Terminals @ 392\ mod_1446193537095_78. docx @ 2808385 @ @ 1
Prerequisite
– Menu “ISOBUS Settings” is called, refer to chapter Terminal - Menus “Menu 14 ‘ISOBUS
Settings’”.
• Select
TIM
to open the menu.
The display shows menu 14-5 “Configurate TIM Software”.
Pos: 45.28.91 /BA/I nfo-Center/ALLE Termina ls in einem - ISOBUS, Delta, BETA II (ab BJ 15/16)/ ALLE Terminals/Rundballe npressen/Menü 14- 5 TIM-Software konfiguri eren_Text_ALLE Termina ls_Comprima F V_+X- treme_Fortima @ 393\mod_1446 193856251_78.doc x @ 2808412 @ @ 1
The following TIM functions can be selected and set:
Icon Explanation
STOP
Activate/deactivate function “Stop tractor when starting the tying
process”
Activate/deactivate function “Open and close bale chamber after tying
process”
Set number of control unit for opening and closing bale chamber.
%
Set percentage of oil amount for opening bale chamber
Activating/deactivating functions
• First select the symbol
STOP
or ; then select the adjacent checkboxes.
• Save the selection.
Setting number of control unit and percentage of oil amount
• Select or % and set required value, see chapter Terminal - Menus, “Change
Value”.
• Save the selection.
Pos: 45.28.92 /Layout Module /---------------Seitenumbruch------------- --- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
