Krone Fortima F 1250 MC - Switch off cutters mechanically

Maintenance
315
Pos: 53.141.7 /BA/Ei nstellungen/Schnei dwerk/Überschri ft Messer mechanisch aussc halten @ 40\mod_126882 0694835_78.doc x @ 362223 @ @ 1
Switch off cutters mechanically
Pos: 53.141.8 /BA/Ei nstellungen/Schnei dwerk/Messer mechanisc h ausschalten @ 39\ mod_1268811740054_78. docx @ 361966 @ @ 1
VP-1-101
4
"0"
3 2
1
Fig. 268
1. Unlock the locking lever (3).
2. Place multipurpose key (1) on blade control shaft (2).
3. Turn blade control shaft (2) with multipurpose key (1) until selector disc (4) is on position
“0”. Position „0“ is located respectively between two settings of cutters.
Pos: 53.141.9 /Layout Module /---------------Seitenumbruch----------- ----- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1