8 SHOCK ABSORBER, SWINGARM 42
300460-01
– Check the heim joint for damage and wear.
» If there is damage or wear:
– Change the heim joint.
8.16 Removing the heim joint
Condition
The shock absorber has been removed.
200577-10
– Clamp the shock absorber in the vise using soft jaws for protection.
– Remove collar bushing 1 of the heim joint.
Pin (T120) ( p. 220)
– Turn over the shock absorber and remove collar bushing 2 of the heim joint.
Pin (T120) ( p. 220)
200578-10
– Remove seal rings 3 on both sides.
200579-10
– Remove lock rings 4 on both sides.
To Next Page
Loading...
