Kurzweil Forte SE - The DSP Control (DSPCTL) Page

Program Edit Mode
The DSP Control (DSPCTL) Page
7-38
In addition to having a selectable function, each function block has three editable
parameters: number of inputs, number of outputs, and block size (the Output Mode
parameter is an editable parameter of the algorithm as a whole). When you rst enter
the EditAlg page, there will be a cursor in the parameter eld, and the rst block of the
algorithm will be highlighted. To select a block for editing, move the cursor down the display
until no parameter eld is highlighted; then, using the < and > buttons, highlight the block
you wish to edit. Press the ^ button to move the cursor back into the parameter elds, and
then select the parameter you wish to edit.
e Output Mode parameter determines the number of outputs from the algorithm. With
Output Mode set to Normal, the algorithm has one output. With Output Mode set to Sep.
L/R, the algorithm has two outputs, each of which is sent to a separate stereo channel.
To edit the signal path, select either an input of a block or an output of the entire algorithm.
By scrolling with Alpha Wheel or the Previous- and Next+ buttons, you can see every
possible conguration for that selected signal path.
The DSP Control (DSPCTL) Page
Before reading further, be sure to read Algorithm Basics on page 7-32 and Common DSP
Control Parameters on page 7-33.
Press the DSPCTL soft button to call up the DSP Control (DSPCTL) page, which is
displayed below:
Function Parameter Range of Values Default
Pitch
Pitch -128 to 127 semitones 0
Fine Adjust ± 100 cents 0
Hertz Adjust ± 10.00 Hertz 0
Key Tracking ± 2400 cents/key 0
Velocity Tracking ± 7200 cents 0
(Function 1-4) (Function-Parameter) (Depends on Function) (Depends on Function)
Level
Level -96 to 24 decibels -6
Key Tracking ± 2.00 decibels/key 0
Velocity Tracking ± 96 decibels 35