Kurzweil Forte SE - KB3 Editor: the Tone Wheels (TONEWL) Page

Program Edit Mode
KB3 Editor: The Tone Wheels (TONEWL) Page
7-85
VolAdjust
Adjust the pre-FX volume of the KB3 signal. Use the Output page OutGain parameter to
adjust the overall post-FX program volume (see "KB3 Editor: The OUTPUT Page" on page
7-95 for details).
BendRngUp, BendRngDn
Respectively control the upward and downward pitch bend ranges of the KB3 program.
KB3 Editor: The Tone Wheels (TONEWL) Page
KB3 Mode uses DSP-generated waveforms for the lower half of its tone wheels and samples
for the upper half of its tone wheels. Using the parameters on the TONEWL page, you can
specify which sample you wish to use, the number of tone wheels (which will aect how
many other voices are available to you), and other related settings.
Parameter Range of Values
Upper Tone Wheel Keymap Sample List
Upper Volume Adjust -96 to 24 dB
Number of Tone Wheels 24 to 91
Organ Map Equal, Peck’s, Bob’s, Eric’s
Wheel Volume Map Equal, Bright, Mellow, Junky
Globals On, Off
Lower Transposition -120 to 127 semitones
Upper Transposition -168 to 87 semitones