Kurzweil Forte SE - KB3 Editor: the Drawbars (DRAWBR) Page

Program Edit Mode
KB3 Editor: The Drawbars (DRAWBR) Page
7-87
Globals
is parameter aects LFO2, ASR2, and FUNs 2 and 4. When o, these modulation sources
are local; the sources aect each individual note in the the program separately and each per-
note source is retriggered each time a note is triggered.
When the Globals parameter is set to On, these modulation sources become global, that is
they aect every note in the current program simultaneously (they are not re-triggered per-
note). When these control sources are global, they begin operating as soon as the program
is selected. When Globals are on, LFO2, ASR2, and FUNs 2 and 4 will appear on their
respective pages preceded by the letter G to indicate that they’re global.
Note that due to the nature of KB3 mode, setting Globals to O may sound similar to
setting Globals to On, because each KB3 note (or "tonewheel") begins playing (internally)
nearly simultaneously as soon as a KB3 program is selected.
Lower Transpose / Upper Transpose
ese two parameters let you transpose the upper and/or lower tone wheels in semitone steps
away from their default tunings.
KB3 Editor: The Drawbars (DRAWBR) Page
Press the DRAWBR soft button to view the Drawbars Page. is page lets you edit the
settings of KB3 program’s drawbars. Note that the drawbar volume values on this page
correspond with the drawbar settings on the Parameters page.
Mode
When you set Mode to Preset, the preset drawbar volume settings on this page (and/or the
corresponding drawbar settings on the Parameters page) will be used when the program is
selected.
When you set Mode to Live, no preset drawbar volume settings will be used when the
program is selected, and the current position of the sliders will determine the drawbar
volume settings.