Kurzweil Forte SE - Page 157

Program Edit Mode
KB3 Editor: The Drawbars (DRAWBR) Page
7-88
In both modes, the drawbar volume settings will immediately change as soon as you move a
corresponding slider.
Steps
is parameter lets you specify the increments by which drawbar volumes will change.
Choose either 0–8, to approximate the drawbar settings on actual organs, or choose 0–127
for a ner degree of resolution.
Volume
is parameter appears only if you’ve set Mode (see above) to Preset. Use the Volume
parameter to set the preset volume of each of the nine drawbars. e available values will be
0–8 or 0–127, depending on the setting of the Steps parameter.
Tune
is parameter lets you tune each of the nine drawbars up or down in semitone steps. e
values for the Tune parameter on the DRAWBR page shown above represent standard
drawbar settings on a real B3, as shown in the table below.
Subharmonics Fundamental Harmonics
16’ 5
1
/3’ 8’ 4’ 2
2
/3’ 2’ 1
3
/5’ 1
1
/3’ 1’
Slider A Slider B Slider C Slider D Slider E Slider F Slider G Slider H Slider I
Figure 7-2 Standard Drawbar Settings for the Hammond B3