Kurzweil Forte SE - The Layer FX (LYR_FX) Page

Program Edit Mode
The Layer FX (LYR_FX) Page
7-16
main Insert Output to Sec.—keep in mind that by this method, the dry signal is sent to the
auxiliary audio outputs.
When Type is set to %, the Aux Send parameter values are in units of percent (%). e
value specied in the Aux Send parameter is the percentage of which the wet auxiliary signal
comprises the nal signal—the insert signal comprises the rest of the nal signal. To hear
equal parts wet signal and dry signal on the main audio output, set the main Insert eect to 0
None and the Insert Output to Main, and set the Aux 1 eect to your desired eect and the
Aux 1 Output to Main. en, set the Aux1 Send to 50%. If you want to hear only the wet
signal, set the Aux1 Send to 100%.
Aux1 Mod, Aux2 Mod
e Aux Mod parameter gives you real-time control over the amount of program signal sent
to the aux eects chain. You can set the Aux Mod parameter to any Forte SE control source.
e amount that you specify for the Aux Send parameter is the maximum value that the Aux
Mod control source can send—the minimum value is 0.
The Layer FX (LYR_FX) Page
Press the LYR_FX soft button to call up the Layer FX (LYR_FX) page. On this page, you can
apply layer-specic eects. ere are three Layer FX Modes: Use Program FX, Layer-Specic
FX, and Use Another Layer’s FX.
Use Program FX Mode
With Use Program FX Mode selected, the current layer will use the eects congured on the
Program FX (FX) page. See The Program FX (FX) Page on page 7-14 for more information
on program FX.
Layer-Specic FX Mode
With Layer-Specic FX selected, you can congure the eects for the current layer. is
mode’s parameters are similar to those of the FX page. is mode is shown in the following
display: