Kurzweil Forte SE - Selecting Programs

Program Mode
Selecting Programs
6-2
Selecting Programs
e Forte SE can provide up to eight Program Banks (Factory Banks A-D and User
Banks A-D). Factory Banks B-D are reserved for future Forte SE program updates. When
announced, free updates can be downloaded at kurzweil.com.
Each Forte SE Bank has space for 256 Programs, for a total of 2048 possible programs. Each
Bank is split into 16 categories of 16 Programs each.
When you are in Program Mode, there are a few ways to select Programs.
• To select a Program in the current Category, press the relevant Program/Multi button.
• To select a Program in a dierent Category, press the Category button of choice and
then a Program/Multi button to select from the 16 Programs in the Category.
• To select the default Program from a Category, simply press the relevant Category
button.
• Choosing a Program in the User Categories, while in the factory Categories, or
choosing a Program in a factory Category while in a User Category, requires pressing
the User button, followed by a Category button and then a Program/Multi button.
• e Alpha Wheel and the Next and Previous buttons allow you to advance through
the Programs one at a time. When you reach the end of the Category, advancing
further will go the next Category.
• If a Program is assigned to a Favorite button, pressing that button will go directly to
the assigned Program.
• To select a program in a dierent Forte SE Bank, press the Program mode button
while in Program Mode to view the Select Bank page. On the Select Bank page use
the navigation buttons to select a Bank and press the OK soft button (or press the
Program mode button again). en use any of the methods above to select a program
in that Bank.
• When the Global Mode User Type parameter is set to Advanced, and the Global
Mode Sound Sel parameter is set to ID number, programs can be selected by typing
in an ID number using the numbers printed on the Program/Multi buttons, followed
by pressing the Enter button.
For a full list of factory Programs, see Appendix C.